Nickel-Based Alloy Turbine Rotor Turbine Shaft and Compressor Wheel

We have complete and advanced equipment in the current industry, and have always been committed to providing professional and customized Low Medium and High Voltage Static Thyristor Generator, Waste Heat Boiler, Biomass Hot Water Boiler and services for domestic and foreign customers. We promote multi-channel publicity effect to enhance the brand communication power and maintain the corporate image and reputation. We establish the concept of people-oriented safety and strengthen the basic work of safety production. We should take the initiative to assume a certain degree of responsibility for social development and integrate the development of the company with the progress of society.

Products Brief Introduction

The moving steam imparts both a tangential and axial thrust on the turbine shaft, but the axial thrust in a simple turbine is unopposed. To maintain the correct rotor position and balancing, this force must be counteracted by an opposing force. Thrust bearings can be used for the shaft bearings, the rotor can use dummy pistons, it can be double flow- the steam enters in the middle of the shaft and exits at both ends, and a combination of any of these. In a double flow rotor, the blades in each half face opposite ways, so that the axial forces negate each other but the tangential forces act together. This design of rotor is also called two-flow, double-axial-flow, or double-exhaust. This arrangement is common in low-pressure casings of a compound turbine.

Scope of Supply

Dongturbo is the original manufacturer for all kinds of sealing rings for steam turbine, so we can provide you with the very same spare parts of steam turbine as the original manufacturer can do.

- Rotor;

- Moving Blades of Rotor;

- HP/IP/LP Gland Sealing;

- HP/IP/LP Diaphragms;

- Seal Rings;

- Couplings between Steam Turbine and Generator;

- Spcial Studs and Nuts;

- Bolts and Nuts of Turbine Casings;

- Bolts and Nuts of Diaphragms;

- Thrust Bearings and Surport Bearings;

- Gaskets, Srews, Keys, Pins, Washers, Grooved gaskets;

- Turning Gear;

- Babbit Metal Lined Bearings;

- Stem, Disc, Pilot and Sleeve of Main Steam Stop Valves, Combined Steam Valves, Governing Valves;

- Actuators of Control System;

- Steam Strainer;

- Start up Oil Pump and Spare Parts;

- Jacking Oil Pump and Spare Parts;

- Main Oil Pump and Spare Parts;

- Emergency Oil Pump and Spare Parts;

- Condensate Pump and Spare Parts;

- Jet Water Pump and Spare Parts;

- Drainage Pump and Spare Parts;

- Spare Parts of Circulating Water Pump;

- Spare Parts of DEH, TSI, ETS;

We will do our best to maintain our reputation in terms of quality and reliability of the Nickel-Based Alloy Turbine Rotor Turbine Shaft and Compressor Wheel, thus building a good corporate image. With the development of the industry and market competition, our company is facing more and more competition and challenges. In addition to enterprise restructuring to improve competitiveness, technological innovation is also an effective measure. We continue to carry out research and apply the research results to product design and manufacturing.